金石泵业(图)-工业混流泵价格-襄樊工业混流泵

（二）开车前准备：

1、检查地脚螺栓的坚固情况。

2、检查传动皮带松紧程度及安装设备是否安装妥善。

3、检查进、出水管是否进气、漏水。

4、检查填料松紧是否适宜。

5、检查电动机和水泵轴心线是否在同一直线上，工业混流泵维修，直联时，电动机旋转方向是否符合泵的旋转方向。

6、检查泵内有无障碍，襄樊工业混流泵，轴是否卡住，用手转动应轻无杂音。

II. Preparation Before Starting

1. Check the foundation bolts if they are firm.

2. Check the degree of tightness of drive belt and check the

installation if it is suitable.

3.Check the water–in and outpipes if they are leaking water and air.

4.Check the degeree of tightness of padding if it is suitable.

    5.Check the

motor and pump axile lead if they are in the same line and check the direction

of rotation of motor if it is the same with the rotation direction of pump.

    6.Check the

pump if there are barriers ， if the axile locks， there should be no noises when

turing it by hand.

 5、水泵有杂音或振动

 There is noise

 in pump or the pump is vibrating

 1、轴中心没有对正

 2、轴弯曲轴承磨损过大

 3、叶轮平衡性差

 4、地脚螺栓松动

 5、装置不当

 6、叶轮局部阻塞

 7、吸水高度太高、发生汽蚀

 8、泵内掉进杂物

 1.The axile center is not aligning

 2.The axile is bend， the bearing wears

 much

 3.The balance of impeller is not good

 4.The foundation bolts are loose

 5.The assembly is improper

 6.Part of the impeller is blocked

 7.The suction head is too high to produce

 c**itation

 8.There are sundries in pump.

 1、找正

 2、校正或更换轴承

 3、进行静平衡试验和调整

 4、拧紧

 5、检查机组

 6、消除杂物

 7、降低安装位置减低安装高度

 8、清除杂物

 1.Calibrate

 2.Calibrate it or change the bearing

 3.Do the static balancing test and adjust

 it

 4.Tighten it

 5.Check the pump unit

 6.Remove the sundries

 7.Reduce the installation site to reduce

 the installation height

 8. Remove the sundries

HW型蜗壳式混流泵按**标准 新系列而设计的节能产品。其性能指标均达到国 先 水平，省材节能效果显著。

HW Spiral Mixed-flow Pump is an efficient pump designed by latest

national standard.The performance indexes h**e been upto the international

advanced level and the material and energy s**ing result is remarkable.