铺设好的冷热水管一定要用卡扣固定好，避免后期装修过程中水管移位，导致接头脱落、松动，产生漏水隐患。尽量做到每隔60cm就要安装一个卡子，切记卡子安装一定要牢固。成品保护很重要，铺设的水管，避免有重物压在水管上。
Water pipe le
The laid cold and hot water pipe must be fixed with clamps to ***oid the displacement of the water pipe in the later decoration process， which leads to the joint falling off and loosening， and the potential water leakage will occur. Try to install a clip every 60cm， and remember that the clip must be firmly installed. The finished product protection is very important. The water pipe laid should be protected from he***y loads on the water pipe.
ppr水管打压试验
在ppr水管的水路改造好后，ppr复合管，一定要做好打压试验。有机会需自己在现场，并且实际观察压力是否下降，我们可以在接头处裹上报纸，有漏水可以轻松发现。不要等着水泥都铺上了，才去打压试水。
Pressure test of PPR water pipeAfter the transformation of PPR water pipe， the pressure test must be done well. If there is an opportunity，ppr管， we need to be actually observe whether the pressure drops. We can wrap a newspaper around the joint and easily find the leakage. Don"t wait for the cement to be laid before you test the water.
PPR管格与管件连接端面必须清洁、干燥、无油。
用卡尺和合适的笔在管端测量并标绘出热熔深度，热熔深度应符合下表规定：
熔接弯头或三通时，ppr管品牌，按设计图纸要求应注意其方向，在管件和管材的直线方向上，用辅助标志标出其位置。
The connecting end face of PPR pipe lattice and pipe fittings must be clean，合肥ppr管， dry and oil-free.
Measure and plot the hot melt profundity at the pipe end with a caliper and a suitable pen. The hot melt profundity shall meet the requirements of the following table:
When welding elbows or tees， the direction could be noted according to the requirements of design drawings， and the place shall be marked with auxiliary marks in the straight direction of pipe fittings and pipes.
ppr复合管-卡弗龙-合肥ppr管由台州艾菲力塑胶有限公司提供。台州艾菲力塑胶有限公司是从事“塑料制品（不含塑料桶）,橡胶制品（不含橡胶桶）,阀门”的企业，公司秉承“诚信经营，用心服务”的理念，为您提供更好的产品和服务。欢迎来电咨询！联系人：郑总（Rainy）。同时本公司还是从事PPR管，地暖管，PVC管的厂家，欢迎来电咨询。