淮南ppr-ppr管品牌-Gafloon卡弗龙(诚信商家)

ppr水管在连接时，无旋转地把管端导入加热套管内，插入到所标志的深度，同时无旋转地把管件推到加热管上，达到规定标志处。一般地可用心中默读数字法掌握加热时间，或观察管件、管材的加热程度，当模头上出现一圈PPR热熔凸缘时，即可将管材、管件从模头上取下进行下道工序。

When the PPR water pipe is connected， the pipe end is led into the heating sleeve without rotation and inserted to the marked depth. At the same time， the pipe fitting is pushed onto the heating pipe without rotation to reach the specified mark. Generally，ppr管品牌， the heating time can be mastered by reading numbers in heart， or the heating degree of pipe fittings and pipes can be observed. When a circle of PPR hot-melt flange appears on the die head，水管ppr， the pipe and pipe fittings can be removed from the die head for the next process.

PPR管格与管件连接端面必须清洁、干燥、无油。

用卡尺和合适的笔在管端测量并标绘出热熔深度，热熔深度应符合下表规定：

熔接弯头或三通时，按设计图纸要求应注意其方向，在管件和管材的直线方向上，用辅助标志标出其位置。

The connecting end face of PPR pipe lattice and pipe fittings must be clean， dry and oil-free.

Measure and plot the hot melt profundity at the pipe end with a caliper and a suitable pen. The hot melt profundity shall meet the requirements of the following table:

When welding elbows or tees， the direction could be noted according to the requirements of design drawings，淮南ppr， and the place shall be marked with auxiliary marks in the straight direction of pipe fittings and pipes.

ppr管在电气部分：

部分开关、插座被后续的给、排水管道、厨卫风道等掩盖，所以施工前必须结合土建预留预埋，考虑到位。

室内强、弱电插座盒位置不合理，强电盒距弱电盒距离太近，一般要求为20cm，特别是卧室的插座，后期业主装修时插座被衣柜、床遮住，ppr集团，造成业主不满意。

PPR tube in the electrical part:

Some switches and sockets are covered by subsequent water supply and drainage pipes， kitchen and bathroom air ducts， so they must be reserved and embedded in combination with civil engineering.

The location of the indoor strong and weak current socket box is unreasonable. The distance between the strong and weak current boxes is too close. Generally， it is required to be 20cm， especially for the socket in the bedroom. The socket is covered by the wardrobe and bed during the later decoration of the owner， causing the owner dissatisfaction.