压力传感器压力传感器接线
加压后的风再分别通过每层的百叶窗或风阀送往每层的前室或楼梯间。当消防前室或楼梯间的通风压力或压差超过设定值（前室25~30Pa，压力传感器接线，楼梯间40-50Pa）时，位于每层的压力传感器顺即时发出信号报警输入旁通泄压阀控制箱，消防楼梯间压力传感器接线，旁通泄压阀控制箱根据压力传感器的信号打开旁通泄压阀，旁通泄压阀打开后，部分加压送风机送往风管的风通过旁路风管经过旁通泄压阀回到风机前端（红色箭头位置）
The compressed air is then sent to the front room or stairwell of each floor through the shutters or the air valve. When the ventilation pressure or pressure difference in the fire chamber or Stairwell exceeds the set value (25 ~ 30 PA in the Front Chamber and 40-50 PA in the Stairwell) ，消防电梯前室压力传感器接线， the pressure sensor located on each floor immediately sends a signal to the by-pass pressure relief valve control box， the by-pass Pressure Relief Valve control box opens the by-pass pressure relief valve according to the signal of the pressure sensor， part of the pressurized air supply fan to the air duct through the Bypass Air Duct by-pass Relief Valve back to the Fan Front (Red Arrow ition)
压力传感器
Product Features are: 1: The use of sensing technology，电梯前室微压差压力传感器接线， core components imported core body. 2: And Directly Change The sensor signal into changeable passive switch signal with microprocessor circuit. 3: Output Action Point * * * ， High repeatability. 4: This product with new technology to reset the process can be any user requirements.
压力传感器接线-消防电梯前室压力传感器接线-豪鲁邦空调由武城县豪鲁邦空调设备有限公司提供。武城县豪鲁邦空调设备有限公司是从事“正压送风成套设备,前室压力传感器成套系统,安装升降机系列”的企业，公司秉承“诚信经营，用心服务”的理念，为您提供更好的产品和服务。欢迎来电咨询！联系人：危经理。
加压后的风再分别通过每层的百叶窗或风阀送往每层的前室或楼梯间。当消防前室或楼梯间的通风压力或压差超过设定值（前室25~30Pa，压力传感器接线，楼梯间40-50Pa）时，位于每层的压力传感器顺即时发出信号报警输入旁通泄压阀控制箱，消防楼梯间压力传感器接线，旁通泄压阀控制箱根据压力传感器的信号打开旁通泄压阀，旁通泄压阀打开后，部分加压送风机送往风管的风通过旁路风管经过旁通泄压阀回到风机前端（红色箭头位置）
The compressed air is then sent to the front room or stairwell of each floor through the shutters or the air valve. When the ventilation pressure or pressure difference in the fire chamber or Stairwell exceeds the set value (25 ~ 30 PA in the Front Chamber and 40-50 PA in the Stairwell) ，消防电梯前室压力传感器接线， the pressure sensor located on each floor immediately sends a signal to the by-pass pressure relief valve control box， the by-pass Pressure Relief Valve control box opens the by-pass pressure relief valve according to the signal of the pressure sensor， part of the pressurized air supply fan to the air duct through the Bypass Air Duct by-pass Relief Valve back to the Fan Front (Red Arrow ition) 压力传感器
Product Features are: 1: The use of sensing technology，电梯前室微压差压力传感器接线， core components imported core body. 2: And Directly Change The sensor signal into changeable passive switch signal with microprocessor circuit. 3: Output Action Point * * * ， High repeatability. 4: This product with new technology to reset the process can be any user requirements.
产品特点有:
1:采用传感感应技术，部件采用国外进口芯体.
2:并用微处理电路直接把传感器信号变成可更改的无源开关量信号.
3:输出的动作点***，重复性高.
4:本产品着新技术让复位过程均可按用户要求任改动.
部四川消防科学研究所结合国际经验提出余压值的数据。压力控制系统可通过控制旁通阀的开闭，将机械加压送风系统的压力值有效控制在要求的合理范围内-----防烟楼梯间40-50Pa，前室、合用前室、消防电梯间前室、封闭避难层(间)为25-30Pa。欢迎新老客户前来洽谈。
部四川消防科学研究所结合国际经验提出余压值的数据。压力控制系统可通过控制旁通阀的开闭，将机械加压送风系统的压力值有效控制在要求的合理范围内-----防烟楼梯间40-50Pa，前室、合用前室、消防电梯间前室、封闭避难层(间)为25-30Pa。欢迎新老客户前来洽谈
压力传感器接线-消防电梯前室压力传感器接线-豪鲁邦空调由武城县豪鲁邦空调设备有限公司提供。武城县豪鲁邦空调设备有限公司是从事“正压送风成套设备,前室压力传感器成套系统,安装升降机系列”的企业，公司秉承“诚信经营，用心服务”的理念，为您提供更好的产品和服务。欢迎来电咨询！联系人：危经理。