6、轴承发热
The bearing is
hot
1、润滑油脂不足
2、润滑油质量不好或不清洁
3、轴心没有对准
4、轴承松动或磨损
5、皮带太紧
1.Lubricating grease is not enough
2.The quality of lubricating oil is not
good or dirty
3.The axes is not aiming
4.The bearing is loose or attrition
5.The belt is too tight.
1、加油
2、清洗轴承
3、找正
4、修正
5、适当放松
1.Add lubrication oil
2.Wash
the bearing
3.Aligning
4.Amending
5.Loosen it properly
混流泵
轴套用来保护轴不使它与填料直接摩擦，机械密封混流泵厂家，若长期使用中发现轴套磨损过多，机械密封混流泵，必须换轴套。
IV. Axile sleeve is used to protect the axle from friction
with long term using， change the axile sleeve
when the sleeve wears down too much.
（五）水泵轴的两个支承是轴承体内的轴承，轴承体内存有适量润滑脂以润滑轴承。
V. Two supportings of water pump axile are bearings in
bearing body.There is some lubricating grease in bearing
body for lubricating bearing.
7、填料发热
The padding is
hot
1、填料压得太紧或四周紧密度不够2、填料压得偏斜与轴磨损严重
1.The padding is
pressed too tight or the around compactness is not enough
2.The padding is
pressed deflected and the axile wears seriously
1、旋松压盖螺栓高速填料紧密度
2、松开压盖重新均匀地上紧
1.Loosen the gland bolts to adjust
2.Loosen the gland bolts and tighten it again.
机械密封混流泵-泰安金石泵业有限公司-机械密封混流泵厂家由泰安金石泵业有限公司提供。泰安金石泵业有限公司（）在污水泵、杂质泵这一领域倾注了无限的热忱和热情，金石泵业一直以客户为中心、为客户创造价值的理念、以品质、服务来赢得市场，衷心希望能与社会各界合作，共创成功，共创辉煌。相关业务欢迎垂询，联系人：刘经理。