




混流泵
(一) 型号说明:
以250HW-8为例:
250—泵进(出)水口直径为250毫米。
8—泵总扬程为8米。
III. Type Instruction:
Take 250HW-8 for an example:
250-The diameter of inlet /outlet of pump is 250mm.
8-The total head of pump is 8m.
轴套用来保护轴不使它与填料直接摩擦,若长期使用中发现轴套磨损过多,必须换轴套。
IV. Axile sleeve is used to protect the axle from friction
with long term using, change the axile sleeve
when the sleeve wears down too much.
(五)水泵轴的两个支承是轴承体内的轴承,轴承体内存有适量润滑脂以润滑轴承。
V. Two supportings of water pump axile are bearings in
bearing body.There is some lubricating grease in bearing
body for lubricating bearing.
3、安装基础:要求土质坚实牢固。
4、水泵安装时,必须保证泵轴的水平位置。
5、进水管末端应浸入水平面以下一米左右,但须离开泥底半米左右。
6、水泵安装好后,计算允许吸上高度和扬程,在水位稳定的条件下,要求为规定数量值的0.8~1.2倍范围,否则水泵不会正常运行
I.
Installation Principle
1. Installation
Height: Cidering the height according to the rainy season or dry season.The suction
vacuum
height can
not be higher than the adsorbing height.
2. Installation
Location:The location is better to close to the water source as p as
should be not
only
keeping the safety but also shortening the water inlet pipe and reduce the
headloss
在造船、石油开采、载重机等方面广泛应用。2008年船舶产量达到15000吨,载重吨数量占世界市场的21%,到2015年将成为世界第 造船大国。为了保证船的正常航行或系泊,满足船员和旅客的生活需要,每条船都要配有一定数量的、能起相应作用的船用泵,船用泵是重要的辅机之一。S型泵性能范围流量160~18000立方米/时,扬程12~125米,进水口直径150~1400毫米,转速2950、1450、970、730、585、485、360转/分。据不完全统计,在各种船舶辅助机械设备中,各种类型和不同用途的船用泵的总数量,约占船舶机械设备总量的20%-30%,船用泵的价格在船舶设备费用中所占的比重也比较大。在总的造价中,船用泵约占船设备费用的4%-8%,一般情况下,一条中型以上船舶的船用泵采购可达1000万元以上。说到***用泵市场,不可不说我国已经完工的"西气东输"工程,"西气东输"工程中同样需要泵类产品。同时***还要修建其它的输送天 气管线,在这些工程中也都需要大量的泵类产品。
