




混流泵
(一) 型号说明:
以250HW-8为例:
250—泵进(出)水口直径为250毫米。
8—泵总扬程为8米。
III. Type Instruction:
Take 250HW-8 for an example:
250-The diameter of inlet /outlet of pump is 250mm.
8-The total head of pump is 8m.
3.
Installation Base:The soil texture should be firm and solid.
4.
During installation, keep the pump axile in horizontal p ition.
5.The end of
water inlet pipe should be immersed under water in about one meter and far away
from the end of mud in about half meter.
6.After installing the pump,calculate the
suitable suction height and head.Under the stable water level condition,
)注意事项:
1、用皮带传动时,两皮带轮必须对正且平等,否则易掉带或出事故,传动皮带轮应有防护装置,以保证安全。
2、进出水路的各连接法兰盘间,应有胶垫,以防进气,漏水。
3、出水管末端 能浸沉池内或尽量靠近水面,以避免扬程损失。
4、如不用底阀,进水管口淹没水中时,应用铁丝网罩或竹制网罩以防水草等杂物进入叶轮,影响水泵正常运转。
4、水泵使用后一定要注意***,比如说当水泵用完后要把水泵里的水放干净, 是能把水管卸下来然后用清水冲洗。
5、水泵上的胶带也要卸下来,然后用水冲洗干净后在光照处晾干,不要把胶带放在阴暗潮湿的地方。水泵的胶带一定不能沾上油污,更不要在胶带上涂一些带粘性的东西。
6、要仔细检查叶轮上是否有裂痕,叶轮固定在轴承上是否有松动,如果有出现裂缝和松动的现象要及时维修,如果水泵叶轮上面有泥土的也要清理干净