齿轮减速机传动，耗能低，性能优越。摆线针轮减速机是一种采用摆线针齿啮合行星传动原理的传动机型，是一种理想的传动装置，具有许多优点，用途广泛，并可正反运转。
Gear reducer has high tran***ission efficiency, low energy cumption and superior performance. Cycloidal pinwheel reducer is a tran***ission type which adopts cycloid needle tooth meshing planetary tran***ission principle, and it is an ideal driving device. It has many advantages, widely used, and can run in reverse direction.
减速机性能特点
1,产品采用模块化设计,电动机输入,输入轴和孔类型三个方面,并配置脚,法兰安装,适用于各种有效的减变速传动,可以直接取代无级调速,摆线。
2、能源消耗低、噪音低、振动小,减速机达96%。
3,使用特殊的宽带宽压力电动机,当加载在20 hz - 60赫兹频率范围内正常使用。
4、齿轮渗碳淬火热处理工艺,采用独特的低噪声齿齿形设计,确保产品的使用寿命。
Performance characteristics of reducer
1, the product adopts modular design, motor input, input shaft and hole type three aspects, and equipped with feet, flange installation, suitable for all kinds of effective variable speed tran***ission, which can directly replace stepless speed regulation and cycloidal.
2, the energy cumption is low, the noise is low, the vibration is ***all, and the efficiency of the reducer is up to 96%.
3, the use of a special wide band wide pressure motor when loaded in the range of 20 Hz - 60 Hz is normally used.
4, gear carburizing and quenching heat treatment process, using a unique low noise tooth profile design to ensure the service life of the product.
减速机的作用
1)降速同时提高输出扭矩，扭矩输出比例按步进电机输出乘减速比，但要注意不能超出减速机额定扭矩。
2)速同时降低了负载的惯量，惯量的减少为减速比的平方。大家可以看一下一般电机都有一个惯量数值。
The function of the reducer
1) reduce the speed and increase the output torque at the same time. The ratio of the torque output to the multiplying and decelerating ratio of the stepper motor output, but we must be careful not to exceed the rated torque of the reducer.
2) speed reduces inertia of load at the same time, and inertia reduces to the square of deceleration ratio. As you can see, general motors h***e an inertia value.
减速机内部齿面硬度 随着齿轮硬齿面技术的发展，其承载能力大、体积小、重量轻、传动精度高等特点使其应用领域日趋广泛。但为获得硬齿面采用的渗碳淬硬使齿轮产生变形，导致齿 轮传动噪声增大，寿命缩短。
With the development of hard tooth surface technology, the internal hardness of gear reducer has been widely used because of its large bearing capacity, ***all volume, light weight and high tran***ission accuracy. But the carburizing and hardening used to obtain the hard tooth surface causes the deformation of the gear, which results in the increase of the noise of the gear tran***ission and the shortening of the service life.