厦门SS-12F15拨动开关规格及参数福建厂家拨动开关图纸
规格书
SPECIFICATION
DESIGNATION 系列：拨动开关
MODULE NO 型号:SS-12D00
0CIRCUIT 回路： 1P2T
TIMING 切换类型： SHORTING
1． STANDARD TEST CONDTTI*** SHALL BE 5 TO 35℃ IN TEMPERATURE AND 45 TO 85% IN HUMIDITY。
温度5-35℃,湿度45-85%标准状态下测试.
2． OPERATING TEMPERE RANGE—10 TO 60℃。
温度-10~60℃环境内使用.
|
ITEM 项目 |
TEST CONDISTION测试条件 |
PERFORMANCE规格 |
|
|
6.ELECTRONICAL PERFORMANCE 电气性能 |
|||
|
6.1 |
CONTACT RESISTANCE 接触阻抗 |
Being measured at 1kHz ***all current Contact resistance meter. 在1kHz小电流下测量. |
30mΩ max.
30毫欧 以下. |
|
6.2 |
INSULATION RESISTANCE 绝缘阻抗 |
Measurements shall be made following Application of Dc 500V potential Across terminals and across terminals And frame for 1 minute. 在端子之间和端子与壳之间加DC 500V 条件下,持续1分钟测量. |
100MΩ max.
100兆欧 以上. |
|
6.3 |
WITHSTAND VOLTAGE 耐电压 |
AC 500V (50Hz or 60Hz) shall be Applied across terminals and across terminals And frame for 1 minute. 在端子之间和端子与壳之间加AC 500V (50Hz或60Hz) 条件下,持续1分钟测量. |
There shall be no breakdown.
无击穿现象出现. |
|
7.MECHANICAL PERFORMANCE 机械性能 |
|||
|
7.1 |
OPERATING FORCE 动作力 |
Measure at the point 3mm from the tip Of the actuator (knob). 在距离推杆前端3mm作测定点. |
350gf&plu***n;100gf |
|
7.2 |
TERMINAL STRENGTH 端子强度 |
A static force of 500gf being applied In one direction on the tip or the Terminal for 1 minute. 一个500克之静电负荷施加于端子顶部的一个方向持续1分钟. |
There shall be no sign of damage mechanically and electrically. 无任何迹象显示机械及电器 性能之损坏. |
|
7.3 |
ACTUATOR STRENGTH 推杆强度 |
A static load of 1kgf being applied In one direction of actuator for one min 一个1公斤静负荷施加于推杆之一个方向持续 1分钟. |
The deformation shall not be extreme and the actuator shall mechanically work normally. 推杆无变形,可以正常操作. |
|
ITEM 项目 |
TEST CONDISTION 测试条件 |
PEREORMALNCE 规格 |
|
厦门SS-12F15拨动开关规格及参数福建厂家拨动开关图纸
厦门SS-12F15拨动开关规格及参数福建厂家拨动开关图纸