BRECO和BRECOFLEX同步带开口同步带带齿失效的原因及纠正措施

BRECO timing belt opening timing belt with gear failure causes and corrective measures
Corrective measures are mainly the following:
1, designed to make the necessary improvements, to ***oid accidents;
2, opening the number of teeth of the timing belt timing belt design improvements, as far as possible the number of teeth is odd;
3, of preload adjustment;
4, to improve the design of the pulley, an appropriate increase in the diameter of the pulley;
5, the ambient temperature regulation, and the addition of a protective cover to prevent debris mixed;
6, regular equipment inspection, to ***oid accidents.
Timing belt with teeth cut, the crushing of the following reas***:
1, the opening timing belt timing belt overload impact load;
2, the opening timing belt timing belt meshing of teeth too little, or number of teeth is the partial number of the number of Pulley;
3, the preload is too ***all;
4, the synchronous wheel diameter is less than the minimum standa***;
5, the working environment temperature is too high, oil and other contamination;
By external influences timing belt system stops and increase the load within a short period of time.
BRECO同步带开口同步带带齿失效的原因及纠正措施
纠正措施主要有以下几点：
1、对设计进行必要的改进，避免意外事故的发生；
2、对开口同步带同步带的齿数的设计进行改进，尽量使齿数为奇数；
3、对预紧力进行调整；
4、对带轮的设计进行改进，适当的增加带轮的直径；
5、对环境温度进行调节，并增设防护罩避免杂物混入；
6、定期对设备进行检查，避免意外事故的发生。
BRECO和BRECOFLEX同步带带齿剪断、压溃的原因有以下几点：
1、开口同步带同步带过载、大冲击载荷；
2、开口同步带同步带啮合齿数太少，或者齿数是同步带轮齿数的偏数；
3、预紧力过小；
4、同步轮的直径小于***低标准；
5、工作环境温度过高，油污等杂质混入；
6、受到外部影响同步带系统停转，负载短时间内增大。