英国WK6565高频直流偏压源
五種***型且***高可升級到120MHz
6565B A5A /A 10A : 20Hz to 10MHz
6565B B5A /B 10A : 20Hz to 20MHz
6565B C5A /C 10A : 20Hz to 30MHz
6565B D5A /D 10A : 20Hz to 50MHz
6565B E 5A /E 10A : 20Hz to 120MHz
Component tests up to 40A DC bias current
Component inductor tests up to 40A
High accuracy for DC bias current &plu***n;1%
Applicati***: Permits measurement analysis of wound components with levels of DC bias current higher than the standard 200mA for high frequency signals in coils
Control connecti***: Serial Communication Bus controls application of DC current and monitors status of analyzer. Status data includes excessive voltage drop and over temperature
Optional facilities: 6565B bias units may be paralleled, maximum of four same model units
Interlock: Bias safety interlock socket on rear panel of analyzer provides door lock and closed control lines
產品規格
系列依頻率等級分為:
6565B A5A /A 10A : 20Hz to 10MHz
6565B B5A /B 10A : 20Hz to 20MHz
6565B C5A /C 10A : 20Hz to 30MHz
6565B D5A /D 10A : 20Hz to 50MHz
6565B E5A /E 10A : 20Hz to 120MHz
Facilities
Output Current 0 to 10A
Resolution
From 1mA to 1A in 999 steps of 1mA
From 1.01A to 10A in 899 steps of 10mA
Dc Bias current accuracy
&plu***n;1% of set bias current &plu***n; 1mA from 1mA to 1A
&plu***n;1% of set bias current &plu***n; 10mA from 1.01A to 10A
Accuracy of current drive read back &plu***n;1% of set bias current, &plu***n;1 digit
Compliance voltage
9V max at 1V ac drive level*
10V max at 0.25V ac drive level*
Max signal drive level
1V ac rms 20Hz – 49.9MHz*
0.5V rms 50MHz – 120MHz*
Frequency range 20Hz – 120MHz
Measurement protection modes
Over-voltage trip, safety interlock, fan failure,
excess temperature and circuit diagnostic checks
Suitable high current fixtures 1J1026(20A), 1J1027(40A)
Temperature range
Storage -40°C to 70°C
Operating 0°C to 40°C
Full accuracy 15°C to 30°C
Measurement terminals 2-terminals measurement via M8 studs
4-terminal measurement via Kelvin leads and M8 studs
Measurement terminals internally protected by 1.6A fuses against normal inductor back-EMF or accidental disconnection of inductor
Front panel fuses easily replaced
Power input specification
Input supply voltage 85-265V ac rms 47-63Hz via IEC connector
Typical input current 4.2A @ 100-120V, 2.1A @ 220 – 230V
Cooling by 3 internal fans
Mechanical
Case Size (3U) 435mm x 132mm x 522m (W x H x D)
Weight 15kg
*Must be used in conjunction with either a 6500B or 6500P