烟密度测试仪满足DIN53438和DIN4102等相关标准，用单燃烧室检验测定密度。适用于所有塑料、橡胶、纺织品覆盖物、喷涂表面、木材及其他建筑材料等的测试
简要描述：
将厚度不超过25mm的试样（扁形材料、合成材料或装配品）水平放置在密封的试验箱里，在有或没有阴引燃火焰的前提下，对试样施加一定的热量辐射，测量***表面产生的烟气量。
The Wazau ***oke density tester's Combustion Beh***ior Test Equipment
according to DIN 4102 B2 and DIN 53438
Purpose and Application
1.This standard specifies a method for the determination of the beh***iour of normal flamable building materials when exposed to the flame of a burner acc. to DIN 50051 part 1 (DIN EN ISO 6941) under defined conditi***. This test procedure is suitable for controlling the similarity of products with respect to beh***iour when exposed to flames and for comparing the product. In addition to this the test results may give hints to the combustion beh***iour of materials in praxis.
The beh***iour of materials against impact of flames depends in reality among others of the thickness of the product. Therefore if is advisable to execute the test according to this standard with specimen of different thickness.
2. Brief description of the procedure
A vertically arranged specimen, which is placed in the burning cabinet, will be exposed to a defined flame either at the lower edge (K = edge-flaming) or in the middle of the lower half of the sample (F = surface-flaming). The purpose of the procedure is the determin, whether and in which time the top of the flame reaches a defined mark on the specimen.
3. Specimen (sample)
Five each specimen are produced for each procedure.
Procedure K: specimen 190 mm length and 90 mm width Procedure F: specimen 230 mm length and 90 mm width
4. Test rig
The complete test rig c***ists of
♦ Burning cabinet acc. to DIN 50050 part 1, which has to be placed into fume cupboard
♦ Gas burner acc. to DIN 50051 part 1 with connection to propane gas, which can be brought in vertical position for controlling the hight of the flame and can be moved horizontically.
♦ Specimen holder c***isting of two parts for mounting the specimen and fixing it by screws or springs and a device for the vertically mounting of the specimen holder.
♦
In addition to the scope of supply you need a device for measuring the duration of time from the start to the reaching of the measuring mark (accuracy 0.1 sec.) and a device for measuring the thickness of the specimens (accuracy +/- 0.1 mm).
5. Execution of the test
The climate in the laboratory respectively in the fume cupboard should be done acc. to DIN 50014.