CA ISO - 低频信号源

CA ISO - 低频信号源HighlightsOne single load resistor boxIncludes all required load resistor valuesHighly accurate resistors (+/-1%)High temperature stabilityResistors with very low inductanceResistor values 0.5ohm, 1ohm, 2ohm, 4ohm, 10ohm, 20ohm and 50ohmApplicationAutomotive test pulse verification under loaded conditi***In accordance with the pulse verification requirements given in Annex C of ISO 7637-2:2011 and Annex A of ISO 16750-2:2012, test pulses generated by automotive transient generators need to be verified both under no-load (open circuit verification) and loaded conditi*** with specified loads. The values of the load resistors is specified and are equal to the generator's internal source impedance defined for the corresponding test pulse.The CA ISO is a resistor box containing all load resistors required to verify micropulse and load dump generators according to international standa*** and manufacturer requirements.标准ISO 16750-2ISO 7637-1:1990ISO 7637-2:1990BenefitsSelection of load resistorsThe set of load resistors has been well selected in order to meet the wide range of source resistors specified in various national/international standa*** and vehicle manufacturer specificati***.The following load resistors are most used:0.5 Ohm for Load Dump pulse verification as per a number of manufacturer specificati***1.0 Ohm for Load Dump pulse verification as per a number of manufacturer specificati***2.0 Ohm for verification of pulse 2a and pulse 5 as per ISO 7637-2 and various manufacturer specificati***4.0 Ohm for verification of pulses 1, 2 and Load Dump pulse 5 as per various manufacturer specificati***10.0 Ohm for verification of pulses 1 and 2 as per ISO 7637-2 and various manufacturer specificati***20.0 Ohm for verification of pulse 1 as per ISO 7637-2 and various manufacturer specificati***.All load resistors are non-inductive and h***e a tolerance better than 1% as per standard requirements. They show sufficient power dissipation for the transient pulse energy. Use of CA ISOCA ISO放大The CA ISO verification box is directly plugged into the CDN outputs of the transient generator. The required load resistor is selected by the bridge connector. The w***eform across the load resistor is best measured by a 100:1 voltage probe with sufficient bandwidth and voltage capability. EM TEST recommend a bandwidth of 20MHz minimum and a voltage measuring capability of 1,-ISOAgilent HP 70950A光谱分析仪Agilent HP 70950B光谱分析仪Agilent HP 70951A光谱分析仪Agilent HP 70952B光谱分析仪Zygo 7701C/ELaser Head 6mmAgilent HP 8147光时域反射仪Agilent HP 81521A光探头Agilent HP 81521B光探头Agilent HP 81522A光传感头Agilent HP 81524A光探头 Agilent HP 81525A光探头Agilent HP 8152A光功率计Agilent HP 81531A光功率计传感插件Agilent HP 81532A传感器Agilent HP 81533A光功率计传感插件Agilent HP 81533B光探头接口模块Agilent HP 81534A光回损插件Agilent HP 81536A光功率计传感插件Agilent HP 8153A光波万用表（光功率计）Agilent HP 81552***光源模块Agilent HP 81554***1310/1550nm 激光源