企业资质

南澳电气(武汉)有限公司

普通会员8
|
企业等级:普通会员
经营模式:
所在地区:湖北 武汉
联系卖家:
手机号码:
公司官网:www.nanaoelec.com
企业地址:
本企业已通过工商资料核验!
企业概况

南澳电气(武汉)有限公司(简称“南澳电气”),是国电网武汉高压研究所改制后成立的高电压输变电检测设备的高新骨干企业,主要从事电力仪器仪表、交直流分压器、互感器类测试设备、高压耐压设备、峰值电压表、超声局放定位系统、工频信号发生器、冲击电压电流发生器、变压器类试验设备、继电保护测试仪、SF6及开关类检......

南澳电气NAGP工频信号发生器

产品编号:7299458                    更新时间:2018-03-21
价格: 来电议定
南澳电气(武汉)有限公司

南澳电气(武汉)有限公司

  • 主营业务:电力系统设备及自动化控制系统技术的开发、研制及技术服务;电子...
  • 公司官网:www.nanaoelec.com
  • 公司地址:

联系人名片:

联系时务必告知是在"产品网"看到的

产品详情

南澳电气NAGP工频信号发生器

NAGP frequency signal generator

一、南澳电气NAGP工频信号发生器概述

   南澳电气NAGP工频信号发生器采用单片机波形合成发生器产生高精度,低失真的正弦波电压,可用于校验频率继电器,同步继电器等,也可作为低频变频电源使用。

 南澳电气NAGP工频信号发生器具有读数直观,***,性能稳定,操作方便等特点。关键器件采用进口元件,是一种有着较高性能价格比的试验仪器。

二、南澳电气NAGP工频信号发生器基本原理

 南澳电气NAGP工频信号发生器工频信号发生器,主要由数字波形发生部分、功率放大部分、以及***控制单元等组成。通过前面板控制数字波形发生单元产生一个频率及幅度非常稳定的数字合成的正弦波,然后送到功率放大器进行放大。***后经过输出切换及短路保护后输出。***控制单元则负责测量输出频率及输出幅度,并监视整个系统的工作状态是否正常。

三、南澳电气NAGP工频信号发生器技术指标

项目

技术指标及参数

备注

频率输出范围

1Hz ~ 100Hz

正弦波

波形失真度

0.5%

 

电压输出范围

0 ~ 450V

 

额定输出功率

50VA

 

电压测量准确度

&plu***n;1%&plu***n;2个字

满量程

频率测量准确度

&plu***n;0.02%&plu***n;2个字

 

电源

220V&plu***n;10%

 

工作环境

环境温度:0°~40°

相对湿度:≤80%

 

 

One. Overview

This instrument uses single-chip w***eform synthesis generator produces high-precision, low distortion sine w***e voltage, can be used to calibrate frequency relays, synchronous relays, etc., can also be used as low-frequency inverter power supply.

This instrument has a reading intuitive, accurate, stable performance, easy to operate and so on. Key components of the use of imported components, is a high performance and low cost of the test equipment.

Two. Basic principles

NAGP Frequency signal generator, mainly c***ists of digital w***eform generation part, power amplifier part, and the central control unit and so on. Through the front panel control digital w***eform generation unit produces a very stable frequency and amplitude of the digital synthesis of sine w***e, and then sent to the power amplifier for amplification. Finally, after the output switching and short circuit protection output. The central control unit is resp***ible for measuring the output frequency and output amplitude, and monitor the work of the entire system state is normal.

Three. Technical indicators

Items

Technical indicators and parameters

Remarks

Frequency output range

1Hz ~ 100Hz

Sine w***e

W***eform distortion

0.5%

 

Voltage output range

0 ~ 450V

 

Rated output power

50VA

 

Accuracy of voltage measurement

&plu***n;1%&plu***n;2个字

Full range

Accuracy of Frequency measurement

&plu***n;0.02%&plu***n;2个字

 

Supply power

220V&plu***n;10%

 

Working environment

Ambient temperature: 0 ° ~ 40 °

Relative humidity: ≤ 80%

 

南澳电气(武汉)有限公司电话:传真:联系人:

地址:主营产品:电力系统设备及自动化控制系统技术的开发、研制及技术服务;电子...

Copyright © 2024 版权所有: 产品网店铺主体:南澳电气(武汉)有限公司

免责声明:以上所展示的信息由企业自行提供,内容的真实性、准确性和合法性由发布企业负责。产品网对此不承担任何保证责任。