进口带切割装置潜水排污泵/Sewage pump/德国巴赫
进口带切割装置潜水排污泵（BACH）产品介绍：
进口带切割装置潜水排污泵，是开发生产***新排污机具，它具有排污通过能力特别强，带切割性能好，能将污水中的长纤维、塑料、纸、带、布条、稻草、绳子等杂质切碎后排出，采用******的方法，设计成***合理的水力特性，使电泵可以全扬程运行，优良的干式电机和水泵的***佳组合，电泵采用高质量的硬质合金，双端面机械密封和骨架油封组合的动密结构，为了电泵的正常运行及工作人员的安全，用户应配备电动机的漏电保护器，在长时间内工作，本泵电机允许露出液面部位，不得超过电动机高度的l/2，抽送污物温度不超过40℃。
Imported submersible sewage pump with cutting device is the latest sewage disposal equipment. It has strong sewage disposal capacity and good cutting performance. It can cut long fibers, plastics, paper, tape, cloth, straw, rope and other impurities in sewage and discharged them. The most advanced method is adopted to design the most reasonable hydraulic characteristics. In order to make the electric pump run at full lift, the best combination of dry motor and water pump is excellent. The electric pump adopts high quality cemented carbide, double-end mechanical seal and skeleton oil seal. In order to ensure the normal operation of the electric pump and the safety of the workers, users should equip the leakage protector of the electric motor for a long time. When working, the motor of the pump is allowed to expose the liquid surface, and the height of the motor must not exceed 1/2. The temperature of the sewage to be pumped should not exceed 40 C.
进口带切割装置潜水排污泵（BACH）适用范围：
(1)用于建筑工地、工程基础施工、市政设施、自来水厂。
(2)各种高楼大厦的地下室、人防坑洞、地铁等地下层污水排放。
(3)中小型企业污水处理及循环水输送。
(4)食品、造纸、酿造、钢铁及有色金属、制革、纺织、制药、水泥厂等厂矿企业的渣浆液抽送。
(1) Used in c***truction site, engineering foundation c***truction, municipal facilities and water works.
(2) Discharge of sewage from basement, civil air defense pit and subway of various high-rise buildings.
(3) Sewage treatment and circulating water transportation in ***all and medium-sized enterprises.
(4) Slag slurry pumping from food, paper, brewing, steel and non-ferrous metals, tannery, textile, pharmaceutical and cement factories.
进口带切割装置潜水排污泵（BACH）安装说明;
(1)电泵使用之前，须首先检查电缆有否损坏，搬运和安装水泵时切勿拉址或损伤电缆以免电缆***后漏水造成事故。如电缆硬裂后应立即更换电缆。并用兆欧表检查电泵的绝缘电阻是否正常(绝缘电阻不得小于1兆欧)。
(2)认清接地线(地线一般为黄、绿双色或接有接***志)，按规定程序接妥地线。(本公司接地线配有接***志。)
(3)选用合适的保护器(如漏电保护器，空气开关，断相过流保护器等)切勿用闸刀开关直接连接。
(4)按标准接好电源线，试接电源，检查电泵运转是否正常，并判断转向是否正确，若转向不正确，将三根电源线中的任意二根对换接好即可(注意运转时间不能超过半分钟)。
(5)装婷出水接头及出水胶管(或铁管)，在电泵提手上结好绳索(***不能用电缆代替吊绳使用)，将电泵放入被抽液体中，接通电源，即可使用。
(6)为了确保人身安全，在电泵接电工作期间，严禁在电泵附近安装下水作业(如移动和检查、排除故障等)，接触电泵以防万一电泵漏电而发生事故!
(7)严禁电泵整体露出水面长期运行(或短时间运行)电泵的。“开”、 “停”不宜过分频繁以防电机过热损坏。
(8)长期抽送高含砂量的液体对本泵的过流部件磨损较大，推荐使用本厂旋流式污水污物潜水电泵产品。
(1) Before using the electric pump, it is necessary to check whether the cable is damaged or not. When handling and installing the pump, do not pull or damage the cable in order to ***oid leakage after the cable breaks. If the cable is hard, it should be replaced immediately. The insulation resistance of the pump is checked by megohmmeter (the insulation resistance should not be less than 1 megohm).
(2) Recognize the grounding line (the grounding line is usually yellow or green or connected with the grounding mark), and connect the grounding line in accordance with the prescribed procedures. The company's grounding wires are equipped with grounding marks. )
(3) Choose appropriate protectors (e.g. leakage protector, air switch, phase-breaking overcurrent protector, etc.) and do not connect directly with switch.
(4) Connect the power cord according to the standard, try to connect the power supply, check whether the pump is running properly, and judge whether the steering is correct. If the steering is incorrect, replace any two of the three power lines (pay attention to the operation time can not exceed half a minute).
(5) Install Tingting outlet joint and outlet hose (or iron pipe), tie the rope on the pump handle (absolutely can not use cable instead of suspension rope), put the electric pump into the pumped liquid, connect the power supply, and then use it.
(6) In order to ensure personal safety, it is strictly forbidden to install launching operati*** (such as moving and checking, troubleshooting, etc.) near the electric pump during the working period of connecting the electric pump, so as to contact the electric pump in case of an accident caused by leakage of the electric pump.
(7) It is strictly forbidden for electric pumps to operate for a long time (or for a short time) when they are exposed to water as a whole. "On" and "off" should not be too frequent in order to prevent motor overheating damage.
(8) Long-term pumping of high sand content liquid wears the flow parts of the pump seriously. It is recommended to use the swirl sewage sewage submersible pump products of our factory.