BRAGA MORO蓄电池-中国
资讯库用于支持SNMP网路设备的模块，其中存有该网路设备之状态资讯，以供网管或使用者对其设备状态查询。互动式UPS的一种工作，基本结构由双向逆变器电池和切换开关组成。电网失败时由逆变器向负载供电，电网正常时逆变器转而向电池充电。实际容量实际容量是指蓄电池放电时所测得的容量，取决于活性的量及利用率，活性与铅板相关，但并不等同于铅重量，与利用蓄与蓄电池极板的结构形式放电电流的大小温度终止电压原材料及制造工艺技术和使用有关，而且是变化的，当今，已知单块极板大容量为A·h/V。安装注意事项安装蓄电池时，请务必遵守以下事项:．不要在密封空间或火的附近安装蓄电池，否则有引发***及火灾的***。．不要用乙烯薄膜类有可能引发静电的东西盖住蓄电池，产生静电时有时会引起***。．不要在有可能进水的地方安装蓄电池，否则有发生触电火灾的***。．请不要在超过-°C~°C环境下安装蓄电池。．不要在有粉尘的地方使用蓄电池，否则有可能造成蓄电池短路。．将蓄电池放进箱内使用时，要注意空气流通。．不要有粘性或标贴类物体压住上盖，因上盖下面有排气阀，电池内产生的气体将不能逸出。
A. battery capacity conversion curve
B. for 5 seconds and 1 minute discharge characteristic curve
C. Float charging pressure and temperature curve
D. Floating battery life and temperature curve
E. Different ratio for battery discharge impulse discharge current curve after 1 hour
F. Different ratio for battery discharge impulse discharge current curve after 0.5 hours
G. Battery capacity and discharge time curve
H. Different battery discharge rate, voltage and time relation curve
For all provide engineering special seal shall be affixed to the drawings, and for the final drawings.
7.1 the basic requirements
7.1.1 during this part for the implementation of the contract party to the quotation of the equipment supplied by inspection and performance test experiment was carried out, ensure the equipment to be provided by quotation in compliance with the requirements of the technical specification. Equipment and its main components are conducted in accordance with relevant state standard type test, factory test, all kinds of test are conducted according to relevant standa*** and regulati*** of the state. Each group, all battery factory experiment was carried out, and to provide a complete test report and factory test reports and test acceptance criteria.
7.1.2 offer party shall within one month after the contract comes into force, to make an inquiry in connection with this contract equipment to be supplied by inspection, performance acceptance test criteria, and in the test report will be a month ago test standa***, plans and reports to send inquiry party inspection. Relevant standa*** shall comply with the provisi*** of the technical specification.
7.1.3 offer will match all equipment field test of the machine.
7.1.4 inquiry think a test condition, content, procedure, measure and record any item is not in conformity with the relevant requirements, shall h***e the right to refuse to accept the test report to redo the test.
